西安拘刺装饰设计工程有限公司

|  CN  
How to open peek injection mold?
Release time:2021.12.02
?

29.jpg

PEEK is a thermoplastic material, and the mold needs to be heated during injection, which requires the mold to have a corresponding heating temperature measurement system, and the template is required to maintain sufficient strength under high temperature and high pressure. In addition, when injecting fiber-containing PEEK raw materials, the requirements for mold materials will be higher, otherwise the mold life will be shorter.

Pay attention to when peek injection:

1. The uniformity of mold heating distribution;

2. The gate and runner are designed to be half of the thickest wall thickness of ultra-thick parts;

3. The pressure setting during injection molding should be higher than half of the plastic;

4. For parts with high dimensional accuracy requirements, heat treatment should be carried out after injection molding;

5. The mold and molten material have high temperature, so pay attention to safety to prevent burns.

The structural design of PEEK injection mold is similar to that of ordinary molds, but the following conditions need to be considered separately: the material of the mold needs to be able to maintain sufficient strength at high temperatures, the injection gate and runner are larger than normal, and the mold needs to be equipped with corresponding The heating temperature measuring device.

Return Next:What is the difference between PVDF and PEEK?

Wechat

Mailbox

Top

巴林右旗| 文登市| 渭南市| 开封县| 进贤县| 瑞安市| 时尚| 西昌市| 屏南县| 台北县| 汤阴县| 外汇| 蒙阴县| 柏乡县| 丹阳市| 平乡县| 孝义市| 南木林县| 唐海县| 越西县| 黄大仙区| 长沙县| 余干县| 雅安市| 南郑县| 万荣县| 上饶市| 张掖市| 沁阳市| 四会市| 阿拉善左旗| 花垣县| 营山县| 新乡市| 齐齐哈尔市| 台安县| 什邡市| 滦平县| 湖口县| 阿合奇县| 丰宁|